Safetor Anchor Mounting Brackets
Safetor Anchor Products can be purchased through any Safetor Recommended Installer Link
Important
Welding anchors to structures
Any structural height safety anchor point should be
bolted and
not welded directly to the structures, if the
anchor became damaged due to an impact or loading the anchor may have to
be replaced. If the anchor is welded to a structure the cost to have the anchor
removed would be high and very time consuming.
All prices exclude GST & Freight |
$240.00 + GST
SHS 120 This mounting bracket is designed to mount the SE015 or SE002 Safetor Anchors
Brochure

|
$280.00 + GST
C/P-01 Top Welded Mounting Bracket
|
$320.00 + GST
C/P-02
Top & Side Bolted Mounting Bracket 
|
|
|
|
$280.00 + GST
C/P-03 Side Welded Mounting Bracket
|
|
$320.00 + GST
C/P-04 Side Bolted Mounting Bracket
 |
Structures:
Our range of anchor mounting brackets will suit most types of
structures or we can design them to suit.
Bolted/Welded
The mounting brackets are either welded or bolted to the
structure and the anchor is then attached to the bracket.
Load Rating
All of our top and side mounted brackets are braced and will withstand loads of up to 21kN
Material
Our range of Safetor mounting brackets are manufactured from 10mm mild steel
NB: Bolts/nuts/washers and freight not included in price

Warning:
Only competent users who have received training should use this equipment.
(Refer to the AS/NZS 1891.4:2009 recommendations concerning selection, use and maintenance.)
Back to products